2019 Ford Fusion Owners Manual - Doors and Locks



Doors and Locks

You can use the power door lock control or the remote control to lock and unlock your vehicle.

The power door lock control is on the driver and front passenger door panels.

Pull the interior door handle twice to unlock and open a rear door. The first pull unlocks the door and the second pull opens the door.

You can use the remote control at any time. The luggage compartment release button only works when your vehicle speed is less than 3 mph (5 km/h).

E138628

A B

Unlock. Lock.

Press the button to unlock the driver door. Press the button again within three seconds to

unlock all doors. The direction indicators flash.

Press and hold both the lock and unlock buttons on the remote control for three seconds to change between driver door or

An LED on the door window trim illuminates when you lock the door. It remains illuminated for up to five minutes after you switch the ignition off.

When you electronically lock your vehicle, the power door lock switch no longer operates after 20 seconds. You must unlock your vehicle with the remote control or keyless keypad, or switch the ignition on, to restore function to these switches. You can switch this feature off in the information display.

See General Information (page 97).

Note: Switch the ignition on and off after changing the setting in the information display.

all doors unlock mode. The direction indicators flash twice to indicate a change to the unlocking mode. Driver door mode only unlocks the driver door when you press the unlock button once. All door mode unlocks all doors when you press the unlock button once. The unlocking mode applies to the remote control, keyless entry keypad and intelligent access. You can also change between the unlocking modes using the information display. See General Information (page 97).

Press the button to lock all doors. The direction indicators will flash.

64

Press the button again within three seconds to confirm that all the doors are closed. The doors will lock again, the horn will sound and the direction indicators will flash if all the doors and the luggage compartment are closed.

If the central locking function does not operate, lock the doors individually using the key in the position shown. On the left-hand side, turn the key clockwise to lock. On the right-hand side, turn the key counterclockwise to lock.

If any door or the luggage compartment is open, or if the hood is open on vehicles with an anti-theft alarm or remote start, the horn sounds twice and the lamps do not flash. You can enable or disable this feature in the information display. See General Information (page 97).

Press twice within three seconds to open the luggage compartment.

Activating Intelligent Access (If Equipped)

You can unlock and lock the vehicle without taking the keys out of your pocket or purse when your intelligent access key is within 3 ft (1 m) of your vehicle.

Intelligent access uses a sensor on the back of the door handle for unlocking and a separate sensor on the face of each door handle for locking.

The system will not function if:

    Your vehicle battery has no charge.
    The key battery has no charge.
    The passive key frequencies are jammed.

Note: The system may not function if the passive key is close to metal objects or electronic devices, for example keys or a cell phone.

Note: If the system does not function, use the key blade to lock and unlock your vehicle. See Remote Control (page 53).

E248553

With your intelligent access key within 3 ft (1 m) of your vehicle, touch the unlock sensor on the back of the door handle for a brief period and then pull on the door handle to unlock, being careful to not touch the lock sensor at the same time or pulling the door handle too quickly. The intelligent access system requires a brief delay to authenticate your intelligent access key fob.

65

E248554

With your intelligent access key within 3 ft (1 m) of your vehicle, touch the outer door handle lock sensor for approximately one second to lock, being careful to not touch the unlock sensor on the back of the door handle at the same time. After locking, you can immediately pull on the door handle to confirm locking occurred without inadvertently unlocking.

Press the exterior release button hidden above the license plate.

This feature helps to prevent you from locking your intelligent access key inside your vehicle’s passenger compartment or rear cargo area.

When you electronically lock your vehicle with any door open, the transmission is in park (P) and the ignition is off, the system searches for an intelligent access key inside your vehicle after you close the last door. If the system finds a key, all of the doors will immediately unlock and the horn will sound twice, indicating that a key is inside.

You can override the smart unlock feature and intentionally lock the intelligent access key inside your vehicle.

To do this, lock your vehicle after you have closed all the doors by:

    Using the keyless entry keypad.
    Pressing the lock button on another intelligent access key.
    Touching the locking area on the front of the door handle with another intelligent access key in your hand.

When you open one of the front doors and lock your vehicle using the power door lock control, all doors will lock then unlock if:

    The ignition is on.
    The ignition is off and the transmission is not in park (P).

Autolock (If Equipped)

Autolock locks all the doors when all of the following occur:

    All doors are closed.
    The ignition is on.
    You shift into any gear putting your vehicle in motion.
    Your vehicle reaches a speed greater than 12 mph (20 km/h).

66

Autolock repeats when:

    You open then close any door when the ignition is on and your vehicle speed is 9 mph (15 km/h) or lower.
    Your vehicle reaches a speed greater than 12 mph (20 km/h).

Autounlock unlocks all the doors when all of the following occur:

    The ignition is on, all the doors are closed, and your vehicle has been moving at a speed greater than 12 mph (20 km/h).
    Your vehicle comes to a stop and you switch the ignition off or to the accessory position.
    You open the driver door within 10 minutes of switching the ignition off or to accessory.

Note: If you electronically lock your vehicle after you switch the ignition off with the driver door closed, the doors will not autounlock.

Note: You can switch autounlock and autolock on or off independently of each other.

Autolock is not configurable in all markets. If the autolock settings are not available in your information display, then the system is not configurable. See General Information (page 97).

The interior lamps and some exterior lamps illuminate when you unlock the doors with the remote control.

The illuminated entry system turns off the lights if:

    The ignition is on.
    You press the remote control lock button.
    After 25 seconds of illumination.

The lights will not turn off if:

    You turn them on with the lamp control.
    Any door is open.

The interior lamps and some exterior lamps illuminate when all doors are closed and you switch the ignition off.

The lamps turn off if all the doors remain closed and:

    25 seconds have elapsed.
    You press the push button ignition switch.

If you leave the courtesy lamps, interior lamps or headlamps on, the battery saver shuts them off 10 minutes after you switch the ignition off.

If you leave the ignition switched on, it shuts off when it detects a certain amount of battery drain, or after 45 minutes.

KEYLESS ENTRY (IF EQUIPPED)

The keypad is near the driver window. It illuminates when touched.

67

Note: If you enter your entry code too fast on the keypad, the unlock function may not work. Enter your entry code again more slowly.

E138637

You can use the keypad to do the following:

    Lock or unlock the doors.
    Release the luggage compartment.
    Program and erase user codes.
    Arm and disarm the anti-theft alarm.

You can operate the keypad with the factory-set five-digit entry code. The code is on the owner’s wallet card in the glove box and is available from an authorized dealer. You can also program up to five of your own five-digit personal entry codes.

    Enter the factory-set five-digit code.
    Press 1·2 on the keypad within five seconds.
    Enter your personal five-digit code. You must press each number within five seconds of each other.
    Press 1·2 on the keypad to save personal code 1.

The doors lock then unlock to confirm that programming was successful.

To program additional personal entry codes, repeat steps 1 through 3, then for step 4:

    Press 3·4 to save personal code 2.
    Press 5·6 to save personal code 3.
    Press 7·8 to save personal code 4.
    Press 9·0 to save personal code 5.

You can also program a personal entry code using the touchscreen.

Hints:

    Do not set a code that uses five of the same number.
    Do not use five numbers in sequential order.
    The factory-set code works even if you have set your own personal code.
    Enter the factory-set five-digit code.
    Press and release 1·2 on the keypad within five seconds.
    Press 1·2 and hold for two seconds. You must do this within five seconds of completing step 2.

All personal codes erase and only the factory-set five-digit code works.

The keypad goes into an anti-scan mode if you enter the wrong code seven times. This mode turns off the keypad for one minute and the keypad lamp flashes.

Anti-scan turns off after any of the following occur:

    One minute of keypad inactivity.
    You press the unlock button on the remote control.

68

    You switch the ignition on.
    You unlock the vehicle using intelligent access.

Press and hold 7·8 and 9·0 on the keypad simultaneously with the driver door closed. You do not need to enter a code first.

Enter the factory-set or your personal five-digit code. You must press each number within five seconds of each other. The interior lamps illuminate.

Note: All doors unlock if you switch on the all door unlocking mode. See Locking and Unlocking (page 64).

Enter the factory-set code or your personal code, then press 3·4 on the keypad within five seconds.

Enter the factory-set code or your personal code, then press 5·6 on the keypad within five seconds.

Note: You need to have two programmed keys for this procedure.

    Remove the key blade from the transmitter.

69

E155835

    Remove the rubber covering (A) from the cup holder. With the buttons facing upward and the unlock button facing the front of your vehicle, place the first intelligent access key into the backup slot (B).
    Press the push button ignition switch once and wait a few seconds.
    Press the push button ignition switch again and remove the key.
    Insert the second programmed key into the backup slot, and then press the push button ignition switch.

The factory-set code appears in the information display for a few seconds.

Note: The code may not display until after any other warning messages first display.

WARNING: Do not leave children or animals unattended in the vehicle. On hot days, the temperature in the trunk or vehicle interior can rise very quickly.

Exposure of people or animals to these high temperatures for even a short time can cause death or serious heat-related injuries, including brain damage. Small children are particularly at risk.

Your vehicle is equipped with a release handle that provides a means of escape for children and adults if they become locked inside the luggage compartment.

Adults should familiarize themselves with the operation and location of the release handle.

The handle is located inside the luggage compartment either on the luggage compartment door (lid) or near the tail lamps. It is composed of a material that will glow for hours in darkness following brief exposure to ambient light.

Pull the handle and push up on the luggage compartment door (lid) to open from within the luggage compartment.

E144403

70


Download Manual

Comments