Windows and Mirrors
|
E146
Note: You may hear a pulsing noise when only one of the windows is open. Lower the opposite window slightly to reduce this noise.
Press the switch to open the window. Lift the switch to close the window.
Press the switch fully and release it. Press again or lift it to stop the window.
Lift the switch fully and release it. Press again or lift it to stop the window.
Start the engine.
The window stops automatically while closing. It reverses some distance if there is an obstacle in the way.
|
Pull up the window switch and hold within a few seconds of the window reaching the bounce-back position. The window travels up with no bounce-back protection. The window stops if you release the switch before the window fully closes.
85
E259237
Press the control to lock or unlock the rear window controls. It illuminates when you lock the rear window controls.
You can use the window switches for several minutes after you switch the ignition off or until you open either front door.
You can use the remote control to operate the windows with the ignition off.
Note: You can enable or disable this feature in the information display or see an authorized dealer. See General Information (page 97).
Note: To operate this feature, accessory delay must not be active.
You can only open the windows for a short time after you unlock your vehicle with the remote control. After you unlock your vehicle, press and hold the remote control unlock button to open the windows and vent the moonroof. Release the button once movement starts. Press the lock or unlock button to stop movement.
|
To close the windows and moonroof, press and hold the remote control lock button. Release the button once movement starts. Press the lock or unlock button to stop movement.
|
86
E144073
A B C
Left-hand mirror. Adjustment control. Right-hand mirror.
To fold both mirrors, make sure you switch your vehicle on (with the ignition in accessory mode or the engine running) and then:
Note: Once you press the control, you cannot stop the mirrors midway through their movement. Wait until the mirrors stop moving and press the control again.
Heated Exterior Mirrors (If Equipped) See Heated Exterior Mirrors (page 129). Memory Mirrors (If Equipped)
You can save and recall the mirror
To adjust a mirror:
Push the mirror toward the door window glass. Make sure that you fully engage the mirror in its support when returning it to its original position.
positions through the memory function. See Memory Function (page 135).
The driver exterior mirror automatically dims when the interior auto-dimming mirror turns on.
The outer portion of the appropriate mirror housing will blink when you switch on the turn signal.
Puddle Lamps (If Equipped)
The lamps on the bottom part of the mirror housing light when you use your transmitter to unlock the doors or when you open a door.
(page 211).
87
|
Note: Do not clean the mirror housing or glass with harsh abrasives, fuel or other petroleum-based cleaning products.
You can adjust the interior mirror to your preference. Some mirrors also have a second pivot point. This lets you move the mirror hear up or down and from side to side.
Pull the tab below the mirror toward you to reduce the effect of bright light from behind.
Note: Do not block the sensors on the front and back of the mirror. A rear center passenger or raised rear center head restraint may also block light from reaching the sensor.
The mirror dims to reduce glare when bright lights are detected from behind your vehicle. It automatically returns to normal reflection when you shift the transmission into reverse (R) to make sure you have a clear view when backing up.
88
E138666
Rotate the sun visor toward the side window and extend it rearward for extra shade.
E162197
Lift the cover to switch the lamp on.
MOONROOF (IF EQUIPPED)
|
The sliding shade can be manually opened or closed when the moonroof is closed.
Pull the shade toward the front of the vehicle to close it.
The moonroof controls are located on the overhead console and have a one-touch open and close feature. To stop it during one-touch operation, touch the control a second time.
The moonroof will stop automatically and reverse some distance if an obstacle is detected while closing.
Touch and hold (C) within two seconds of a bounce-back event to override this function.
Touch (B) to vent the moonroof. Touch
E144499
A B C
Open Vent Close
Touch (A) to open the moonroof. It will stop short of the fully opened position.
Note: This position helps to reduce wind noise or rumbling which may happen with the moonroof fully open. Touch (A) again to fully open the moonroof.
Touch (C) to close the moonroof.
89
Download Manual